Grizzly G1028 - ASSEMBLY; Beginning Assembly; Base Assembly

G1028/G1029 Dust Collector -9-
SECTION 4: ASSEMBLY
Beginning Assembly
Assembly of the G1028/G1029 is straightforward.
We have organized the assembly process into
steps. Please follow them in sequence.
Caution: All die-cut metal parts have a sharp
edge (called “flashing”) on them after they are
formed. This is removed at the factory.
Sometimes though, a bit of flashing might escape
inspection. Please examine the edges of all die-
cut metal parts before handling them.
Tools Required: 12mm open end wrench, regu-
lar and Phillips head screwdriver.
Figure 3. Mounting casters to base.
Base
Position the base plate upside down and locate
the casters so they are within easy reach. Mount
the casters to the base plate using sixteen
5
⁄16" -
18 x
1
⁄2" hex bolts provided. Figure 3.