- 4 -
G1071 Oscillating Spindle Sander
II. SAFETY RULES FOR ALL TOOLS - CONT’D
16. DISCONNECT TOOLS FROM
POWER before servicing and when
changing accessories such as sanding
sleeves.
17. USE ONLY RECOMMENDED
ACCESSORIES. Consult the current
catalog for recommended accessories.
Using improper accessories may be
hazardous.
18. AVOID ACCIDENTAL STARTING.
Make sure the switch is in the “OFF”
position before plugging in the cord.
19. NEVER STAND OR LEAN ON TOOL.
Serious injury could occur if the tool is
tipped or if the spindle is accidentally
contacted while running.
20. CHECK DAMAGED PARTS. Before
further use of the tool, any part or guard
that is damaged should be promptly
repaired or replaced. Do not operate
the machine until you are certain that it
is in perfect running condition. Failure
to follow this precaution could result in
further mechanical damage and opera-
tor injury.
21. ALWAYS FEED YOUR WORK
AGAINST THE DIRECTION OF SPIN-
DLE TRAVEL. Workpieces fed in the
same direction as the spindle travel
could be forced out of your control.
22. NEVER LEAVE THE TOOL RUNNING
UNATTENDED - TURN POWER OFF.
Do not leave the tool unattended until it
comes to a full stop.
23. DO NOT OPERATE THE TOOL
UNDER THE INFLUENCE OF
DRUGS, ALCOHOL, OR ANY MED-
ICATION. Never operate machinery
when overly fatigued.
24. DO NOT WORK IN HASTE or operate
machine if you are mentally or physi-
cally fatigued.
25. IF THERE IS SOMETHING YOU DO
NOT KNOW OR UNDERSTAND, DO
NOT OPERATE MACHINE! Ask for
help first. Confusion can be dangerous.
26. BAD HABITS ARE DANGEROUS.
Review all safety procedures often.
These safety rules, while expansive,
may not cover every situation in a wood-
shop. Please consider your unique con-
ditions when setting up and using your
sander.
To Next Page
Loading...
Need help?
General
