- 7 -
G1071 Oscillating Spindle Sander
Take a quick inventory of the parts and put
them aside for later assembly.
Since the majority of the spindle sander is
pre-assembled at the factory, there aren’t a lot
of items to inventory. You should have the fol-
lowing items:
• Spindle Sander Unit
• Sanding Spindles (10)
• Table Inserts (3)
• Spindle Wrenches (2)
• Allen
®
Wrench (1)
VI. PIECE INVENTORY
The table is coated with a waxy oil to protect it
from corrosion during shipment. Remove the
protective coating with common paint thinner
(mineral spirits) and paper towels.
VII. CLEAN UP
Follow the safety rules listed below
when working with solvents.
1. Read and follow all directions and
warnings on the solvent label.
2. Work only in a well ventilated area.
3. Do not work near any type of open
flame (e.g., pilot lights, kerosene
heaters, wood stoves and so on).
4. DO NOT smoke while working with
flammable material.
5. Paper towels from the cleaning
process are extremely combustible.
Dispose of waste towels so they do
not create a fire hazard.
Do not use gasoline or other petroleum-
based solvents because of their extremely
low flash points. Do not use acetone or
chlorine-based solvents – if you happen to
splash some onto painted surfaces, you’ll
damage the sander’s finish.
All die-cut metal parts have a sharp edge
(called “flashing”) on them after they are
formed. This is removed at the factory.
Sometimes, though, a bit of flashing
might escape inspection. Please exam-
ine the edges of all die-cut metal parts
before handling them.
To Next Page
Loading...
Need help?
General
