Figure 14
Figure 14.
Drill Chuck & Arbor
To assemble the drill chuck and mount it to
the spindle:
1.
Failure to clean the mating surfaces
may cause the tapered fit to loosen during
operation, resulting in separation and an
unsafe condition
2.
3.
Figure 15
Steps 1 2
Figure 15.
DO NOT use a steel hammer on the drill
chuck to seat the arbor into the spindle.
You will damage the chuck and/or spindle,
which may make them unusable or unsafe.
Figure 16.
4.
Figure 15
5.
Figure 16.
To Next Page
