DO NOT start tool until all preced-
ing setup instructions have been
performed. Operating an improperly
set up tool may result in malfunc-
tion or unexpected results that can
lead to serious injury, death, or tool/
property damage.
Serious injury or death can result
from using tool BEFORE under-
standing its controls and related
safety information. DO NOT oper-
ate, or allow others to operate, tool
until information is understood.
Figure 7. Location of auxiliary handle and
ON/OFF switch.
Model T32540 (Mfd. Since 10/20)-14-
To test run tool:
1. Clear away all setup/adjustment tools.
2. Connect tool to power supply.
3. While firmly holding auxiliary handle
(see Figure 7) in one hand, move
switch to ON position with opposite
hand. Motor should run smoothly and
without unusual problems or noises.
4
. Move switch to OFF position. Motor
should immediately stop running.
Congratulations! Test run is complete.
ON/OFF
Switch
Auxiliary Handle
Test Run
Before installing attachments and using
your Model T32540, test run the tool to
make sure it runs properly.
If you find an unusual problem during the
test run, immediately stop the tool, discon-
nect it from power, and fix the problem
BEFORE operating the tool again. The
Troubleshooting table in the SERVICE
section of this manual can help.
The test run consists of verifying the fol-
lowing: 1) The motor powers up and runs
correctly.
To Next Page
Loading...
Need help?
General
