the second number while the first number was ‘1’.
3. When the second number is flashing ,single knock to change the number,and
the second number you need to input is ‘2’. Double knock to enter the last
number while the first number was ‘2’.
4. When LCD displays ‘INPUT 123:123’, triple knock to enter the setting
interface.
5. Single knock to ‘COM Address: xxx’, and then double knock to enter the
setting status, single knock to change the COM Address. When setting finishes,
wait for 30s or triple knock to save your setting.
7.2.4 Set inverter display language
1. If you want to set inverter display language, repeat the steps as described in
section 7.2.3.
2. When LCD displays ‘INPUT 123:123’, triple knock to enter the setting interface.
3. Single knock to select the language you want, when setting finishes, wait for 30s
or triple knock to save your setting.
The inverter provides seven languages: English, German, Spanish, Italian,
French,Hungarian and Turkish . The number on Set language interface is sequence
number of these seven languages, the sequence number and its corresponding
language are showing in Table below：
7.2.5 Set inverter time
1. If you want to set inverter time, repeat the steps as described in section 7.2.3.
2. When LCD displays ‘INPUT 123:123’, triple knock to enter the setting interface.
3. Single knock until LCD displaying ‘xxxx/xx/xx xx:xx’, and then double knock
To Next Page
Loading...
