Appendix A
A.1. Appendix
The appendix describes the parts of the CIM 500 webserver
needed for the configuration of a BACnet IP Ethernet connection.
For other CIM 500 webserver features, not specifically related to
BACnet IP, see the installation and operating instructions for CIM
500.
A.1.1. Webserver configuration
The built-in webserver is an easy and effective way to monitor the
status of CIM 500 and configure the available functions and
Industrial Ethernet protocols. The webserver also makes it possible
to update the firmware of CIM 500, and store or restore settings.
To establish a connection from a PC to CIM 500, proceed as
follows:
Before configuration
• Check that the PC and CIM 500 are connected via an Ethernet
cable.
• Check that the PC Ethernet port is set to the same network as
CIM 500. For network configuration, see section How to
configure an IP address on your PC using Windows 10.
To establish a connection from a PC to CIM 500 for the first time,
the following steps are required:
1. Open a standard Internet browser and type 192.168.1.100 in the
URL address field.
2. Log in to the webserver.
Related information
A.1.2. How to configure an IP address on your PC using Windows
10
A.1.2. How to configure an IP address on your PC using
Windows 10
1. Search for "Ethernet" in Windows.
2. Select "Change Ethernet setting".
3. Select "Change adapter options".
4. Right-click "Ethernet" and select "Properties".
5. Select properties for "Internet Protocol Version 4 (TCP/IPv4)".
6. Select the "Alternate Configuration" tab and enter the user-
configured IP address and subnet mask you would like to assign
to your PC.
TM057422
Example from windows 10
28
Appendix A
To Next Page
Loading...
