Grundfos DPC 1-3 User Manual

16 | Page 17 | Page
MANUAL MODE:
Press the MODE key to switch to manual mode. Once the unit is in MANUAL
mode, press the START key to run pump, press the STOP key to stop pump.
NOTE: In manual state, the unit doesn’t receive signal from float switch
or pressure switch.
AUTO MODE:
Press the MODE key to switch to auto mode. Once the unit is in AUTO mode,
the pump will start or stop according to the signal from sensor, float switch or
pressure switch.
FAULTS AND PROTECTION:
During pump running, if dry run, overload, under voltage, over voltage etc.
failures happen, the control unit immediately stops the pump, displays it on the
LCD screen and automatically executes a check for restarting conditions after a
built-in time delay has elapsed. The control unit recovers automatically until all
the abnormal conditions have been cleared. However, the recovery time of the
control unit is different for different faults.
Details of recovery times for each fault have already been explained in this
manual. Recovery time for dry run and overload can be altered and set as per
needs. However, recovery times and values for under and over voltage are factory
set and can’t be altered.
NOTE: To reset immediately without waiting for recovery time, cut off
power supply and again switch on.
MEANING OF THE MESSAGES AND GRAPHIC SHOWN ON
NOTE:
THE LCD SCREEN:
In AUTO mode, if the pump is running and user wants to stop the pump, press
the MODE key to switch to MANUAL mode and pump will stop running.
In AUTO mode, if the input power gets cut off and when the supply gets
restored, the unit will start operating after 10 seconds automatically.
No matter the unit is in AUTO OR MANUAL mode, the unit will resume
operation in same mode when the power supply gets recovered after a cut off.
Liquid l
evel in the upper water tank reaches upper probe or float
switch in up position, pump stop running
Liquid level in the borewell or lower tank is below pump intake,
pump stop running
D R Y R U N
APPLICATION: WATER SUPPLY/TRANSFER (USING PROBES OR FLOATS)
BASIC OPERATION
F U L L

Grundfos DPC 1-3 Specifications

General

Brand	Grundfos
Model	DPC 1-3
Category	Controller
Language	English