English (GB)
22
9.3.1 "Home" display
Fig. 24 Example of ""Home"" display
9.3.2 Startup guide
The motor incorporates a startup guide which is
started at the first startup. See section 10.35 ""Run
start-up guide"". After the startup guide, the main
menus appear in the display.
TM06 4516 2415
Pos. Symbol Description
1
""Home""
This menu shows up to four
user-defined parameters. You
can select parameters shown
as shortcut icon , and when
pressing you go directly to
the "Settings" display for the
selected parameter.
2-
""Status""
This menu shows the status of
the motor and system as well
as warnings and alarms.
3-
""Settings""
This menu gives access to all
setting parameters. You can
make detailed settings of the
motor in this menu.
See section 10. Description of
functions.
4-
""Assist""
This menu enables assisted
motor setup, provides a short
description of the control
modes and offers fault advice.
See section 10.38 ""Assist"".
5
Indicates that the motor has
been stopped via the
button.
6
Indicates that the motor is
functioning as a master in a
multimotor system.
7
Indicates that the motor is
functioning as slave in a
multimotor system.
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3 4
8
Indicates that the motor is
operating in a multimotor
system. See section
10.42 ""Setup of multi-pump
system"" (Multimotor).
9
Indicates that the possibility to
make settings has been
disabled for protective reasons.
See section 10.27 "Buttons on
product" (""Enable/disable
settings"").
Pos. Symbol Description
To Next Page
Loading...
Need help?
General