Grundfos RSI - Page 40

6.1.5 Using the graphical keypad
6.1.5.1 Editing values
The selectable values can be accessed and edited in two different ways on the graphical keypad.
1. Parameters with one valid value
Typically, one parameter is set one value. The value is selected either from a list of values (see example
below) or the parameter is given a numerical value from a defined range (e.g. 0.00...50.00 Hz).
Change value of a parameter following the procedure below:
a. Locate the parameter.
b. Enter the Edit mode.
c. Set new value with the arrow buttons up/down. You can also move from digit to digit with the arrow
buttons left/right if the value is numerical and then change the value with the arrow buttons up/down.
d. Confirm change with OK button or ignore change by returning to previous level with Back/Reset button.

Start/Stop Setup
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
STOP READY I/O
ID:172 M3.2.1

Edit
Help
Add to favorites
Rem Control Place
STOP READY I/O
ID: M3.2.1

Rem Control Place
STOP READY I/O
M3.2.1
I/O Control
FieldbusCTRL

Start/Stop Setup
Rem Control Place
I/O Control
KeypadStopButton
Yes
Start Function
Ramping
STOP READY I/O
ID:172 M3.2.1

Rem Control Place
STOP READY I/O
M3.2.1
I/O Control
FieldbusCTRL
O
K
BAC
RES
OR:
TM078664
Typical editing of values on graphical keypad (text value)
40
English (GB)