TM078665
Typical editing of values on graphical keypad (numerical value)
2. Parameters with check box selection
Some parameters allow selecting several values. Make a check box selection at each value you wish to
activate as instructed below.
TM078666
Applying the check box value selection on graphical keypad
Pos. Description
A Symbol for checkbox selection
6.1.5.2 Resetting fault
1. Instructions for how to reset a fault can be found
in chapter Faults.
6.1.5.3 Function button
The FUNCT button is used for four functions:
1. to quickly access the Control page,
2. to easily change between the Local (Keypad) and
Remote control places,
3. to change the rotation direction and
4. to quickly edit a parameter value.
6.1.5.4 Control places
The control place is the source of control where the
drive can be started and stopped. Every control place
has its own parameter for selecting the frequency
reference source. The Local control place is always
the keypad. The Remote control place is determined
by parameter P.3.2.1 (I/O or Fieldbus). The selected
control place can be seen on the status bar of the
keypad.
41
English (GB)
To Next Page
Loading...
