Grundfos RSI - Page 42

• Remote control place
I/O A, I/O B and Fieldbus can be used as remote
control places. I/O A and Fieldbus have the lowest
priority and can be chosen with parameter P3.2.1
(Rem Control Place). I/O B, again, can bypass the
remote control place selected with parameter
P3.2.1 using a digital input. The digital input is
selected with parameter P3.5.1.7 (I/O B Ctrl
Force).
• Local control
Keypad is always used as control place while in
local control. Local control has higher priority than
remote control. Therefore, if, for example,
bypassed by parameter P3.5.1.7 through digital
input while in Remote, the control place will still
switch to Keypad if Local is selected. Switching
between Local and Remote Control can be done
by pressing the FUNCT-button on the keypad or
by using the "Local/Remote" (ID211) parameter.
6.1.5.5 Changing control places
Change of control place from Remote to Local
(keypad).
1. Anywhere in the menu structure, push the FUNCT
button.
2. Push the Arrow up or the Arrow down button to
select Local/Remote and confirm with the OK
button.
3. On the next display, select Local or Remote and
again confirm with the OK button.
4. The display will return to the same location as it
was when the FUNCT button was pushed.
However, if the Remote control place was
changed to Local (Keypad) you will be prompted
for keypad reference.
Main Menu
Parameters
( 15 )

Diagnostics

STOP READY Keypad
ID: M1
( 7 )
Monitor

( 6 )
ID:
Choose action
STOP Ready Keypad
ID:1805
Local/Remote
Control page
Change direction
?
Remote
ID:
Local/Remote
STOP READY Keypad
ID:211
Remote
Local
Main Menu
Parameters
( 15 )

Diagnostics

STOP READY I/O
ID: M1
( 7 )
Monitor

( 6 )
FUN CT
O K
TM078667
Changing control places
6.1.5.6 Accessing the control page
The Control page is meant for easy operation and
monitoring of the most essential values.
1. Anywhere in the menu structure, push the FUNCT
button.
2. Push the Arrow up or the Arrow down button to
select Control page and confirm with the OK
button.
3. The control page appears
If keypad control place and keypad reference are
selected to be used you can set the Keypad
Reference after having pressed the OK button. If
other control places or reference values are used
the display will show Frequency reference which
is not editable. The other values on the page are
Multimonitoring values. You can choose which
values appear here for monitoring (for this
procedure, see Monitor).
42
English (GB)