Grundfos RSI - Page 67

7.1.5 Extras & advanced
Code Monitoring value Unit Scale ID Description
V2.6.1 DriveStatusWord 1 43
Bit coded word
B1 = Ready
B2 = Run
B3 = Fault
B6 = RunEnable
B7 = AlarmActive
B10 = DC Current in stop
B11 = DC Brake Active
B12 = RunRequest
B13 = MotorRegulatorActive
V2.6.2 Ready status 1 78
Bit coded information about ready criteria.
Useful for debugging when the drive is not
in ready status.
Values are visible as check boxes on
graphical keypad. If checked (x), the value
is active.
B0: RunEnable high
B1: No fault active
B2: Charge switch closed
B3: DC voltage within limits
B4: Power manager initialized
B5: Power unit is not blocking start
B6: System software is not blocking start
V2.6.3 Appl.StatusWord1 1 89
Bit coded statuses of application.
Values are visible as check boxes on
graphical keypad. If checked (x), the value
is active.
B0 = Interlock 1
B1 = Interlock 2
B2 = Reserved
B3 = Ramp 2 active
B4 = Mechanical brake control
B5 = I/O A control active
B6 = I/O B control active
B7 = Fieldbus Control Active
B8 = Local control active
B9 = PC control active
B10 = Preset frequencies active
B11 = Inching active
B12 = Fire Mode active
B13 = Motor Preheat active
B14 = Forced stop active
B15 = Drive stopped from keypad
67
English (GB)