English (GB)
10
3.4.2 Plug connection
3.4.3 Connection without plug
4. Starting up the product
4.1 Priming the pump
1. Unscrew the priming plug and pour minimum 1.7
litres (0.45 gallons) of water into the pump
housing. See fig. 9.
2. Screw the priming plug on again.
4.2 Starting the pump
1. Open a tap to prepare the pump for venting.
2. Insert the power plug into the socket or turn on
the power supply and the pump will start.
3. When water flows without air, close the tap.
4. Open the highest tapping point in the installation,
preferably a shower.
5. Adjust the pressure setpoint to the required
pressure by means of the buttons. See
section 4.3 How to set the correct pressure.
6. Close the tapping point.
Startup has been completed.
Fig. 9 Priming the pump
DANGER
Electric shock
Death or serious personal injury
- Check that the power plug delivered
with the product is in compliance with
local regulations.
- Make sure that the pump is connected
only to a properly grounded,
grounding-type receptacle (protective
earthing).
- The protective earth of the power outlet
must be connected to the protective
earth of the pump. The plug must
therefore have the same PE connection
system as the power outlet. If not, use a
suitable adapter.
The electrical connection must be carried
out by an authorised electrician in
accordance with local regulations.
DANGER
Electric shock
Death or serious personal injury
- The pump must be connected to an
external main switch with a minimum
contact gap of 3 mm (0.12 inch) in all
poles.
Do not start the pump until it has been
filled with liquid.
If the suction depth exceeds 6 m (20 ft), it
may be necessary to prime the pump more
than once.
Always tighten priming and drain plugs by
hand.
TM06 4204 1615
To Next Page
Loading...
Need help?
General
