Grundfos TP 32-40 - TPE Series 2000 Function Overview

TPE Series 2000 pumps
TPE E-circulators
8
16
Overview of functions
E-pump functions TPE Series 2000 with single-phase MLE
Setting via control panel:
Setpoint 
Start/stop 
Max. curve 
Min. curve 
Alarm reset 
Constant/proportional pressure 
Reading via control panel:
Setpoint 
Operating indication 
Fault indication 
Setting via R100:
Setpoint 
Start/stop 
Max. curve 
Min. curve 
Alarm reset 
Controlled/uncontrolled
Constant/proportional pressure, constant curve
Controller constants Kp, Ti
External setpoint signal 
Signal relay function
Pump number (for bus communication) 
Stop function
Sensor range and signal
Duty/standby
Operating range (min./max. speed)
Reading via R100:
Setpoint 
Operating mode 
Actual sensor value 
Pump speed 
Actual power consumption 
Energy consumption 
Running hours 
Setting via GENIbus:
Setpoint 
Start/stop 
Max. curve 
Min. curve 
Controlled/uncontrolled
Constant/proportional pressure, constant curve
Reading via GENIbus:
Setpoint 
Operating indication 
Pump status 
Additional functions:
Parallel operation 
Clock program 
Settings via external signal:
Setpoint 
Start/stop 
Min./max. curve via digital input 
Min./max. curve, external fault, Flow switch via digital input 
Readings via external signal:
Fault signal (relay) 
Fault, Operation or Ready signal (relay)
Available
E-circulator.book Page 16 Friday, October 7, 2011 4:01 PM