20
ON/STB Button:
Push the ON/STB (Standby) button below the Gryphon logo to turn the Commander ON and
again to engage to standby mode. When the preamplifier is ON, the symbol turns green. (A red
symbol indicates STB)
Note: ALWAYS turn the preamplifier on, BEFORE turning on the power amplifier(s). ALWAYS
turn the power amplifier(s) off, BEFORE turning off the preamplifier.
Display View Modes:
The Gryphon Commander has two display view modes: “Operation” and “Distance”. After the
start up sequence completes and when the user is within approximately 70 cm of the display,
the Commander will enter “Operation” mode. 5 seconds after the user gone beyond the 70cm
range, the display will switch to “Distance” mode.
Distance Mode:
In "Distance" mode, the selected input and the volume level are displayed with a large font to
make them easily readable from the listening position.
Operation Mode:
In "Operation" mode, it is possible to operate the Commander via the touch display.
To Next Page
Loading...
