23
GREEN BIAS:
Select the volume level where you want your Gryphon Apex Power Amplifier(s) to change Class
A bias when connected via the Green Bias control feature. Please also refer to the description
in the chapter: "Green Bias".
(All Gryphon Class A power amplifiers are compatible, but some models are programmed to
change at another volume level).
Please note that selecting "BIAS L" on the Apex Power Amplifier will disable Green Bias control.
IR SOURCE:
It is possible to connect an external active IR receiver to the back panel of the Commander. To
use this option; select Rear Panel IR Connector.
P
SU OPTION:
Owners of the Gryphon Legato or Gryphon Legato Legacy can connect their unit to “Analog
PSU 2” left and right.
Use the touch button to enable or disable Analog PSU 2.
Note: The Analog PSU 2 output is enabled after Standby - ON restart. Please remember to
power your power amplifier(s) OFF while restarting.
INPUT LEVEL MATCH:
This option enables individually trimming the gain level of each input to maintain consistent
volume when switching between sources.
Select the desired input and use the arrows up and down to adjust the level from 0 - +8dB.
To Next Page
Loading...
Need help?
General
