To Next Page
S
Sean WalkerAug 29, 2025
What does 'Receive buffers capacity was exceeded' mean on my GSE 350 Touch Panel?
- MMichael SawyerAug 29, 2025
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What does 'Receive buffers capacity was exceeded' mean on my GSE 350 Touch Panel?
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What does 'Re- ~ Boot!' mean on GSE Accessories?
The message 'Re- ~ Boot!' on GSE Accessories means that EEPROM data could not be read and the unit is attempting a power-up reset.
What to do if my GSE 350 displays 'Under Load'?
If your GSE Touch Panel displays 'Under Load', check the load cell wiring.
What to do if my GSE Touch Panel displays 'Trans~Hold2'?
This message on the GSE Touch Panel indicates that data transmission is being blocked because of a deasserted handshake on communication port 2. To resolve this, press the [ZERO] or [CLR] button to stop the transmission and then check P204.
What does 'F.S. ~ TooHi' mean on GSE Accessories?
The message 'F.S. ~ TooHi' on GSE Accessories means that the entered calibration weight will result in an over-capacity condition at full scale. Verify that the full scale (P110) and calibration weight value are correct.
What does 'A-D ~ Bad!' mean on GSE Accessories?
The message 'A-D ~ Bad!' on GSE Accessories indicates a problem with the A/D chip. Disconnect any Or Code17 options installed and re-power the unit.
What does 'T.X.YYYY' mean on GSE Accessories?
The message 'T.X.YYYY' on GSE Accessories means that catastrophic errors occurred in the software, a trap error may occur and freeze the display with address information. Press any key five seconds after viewing message to reboot the unit.
What does 'Tare ~ GT FS' mean on my GSE 350?
The 'Tare ~ GT FS' message on your GSE Touch Panel means that the tare value is greater than the full scale capacity.
What does 'Code 05' mean on my GSE Accessories?
If the GSE Accessories display shows 'Code 05', it means a zero attempt was made beyond that allowed by P118.
What does 'Add ~ Load!' mean on GSE Accessories?
If 'Add ~ Load!' is displayed after performing a count sample on your GSE Accessories, this message indicates that a larger sample size is required.
Instructions for sampling and counting parts, including viewing average piece weight.
Guides on entering target values and tolerances for percentage checkweighing.
Instructions for entering target values for the fill program, including pre-act values.
Steps to enter target and pre-act values for batching ingredients in Model 350 and 355.
Instructions for entering target and pre-act values for the discharge program.
How to enter target values for combined fill and discharge operations.
Guides on entering absolute target values and tolerances for checkweighing.
How to enter target values and tolerances for target deviation checkweighing.
Lists and explains common operational error codes and messages encountered.
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
