To Next Page
S
Sean WalkerAug 29, 2025
What does 'Receive buffers capacity was exceeded' mean on my GSE 350 Touch Panel?
- MMichael SawyerAug 29, 2025
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What does 'Receive buffers capacity was exceeded' mean on my GSE 350 Touch Panel?
The message 'Receive buffers capacity was exceeded' on your GSE Touch Panel indicates a handshaking problem.
What to do if data transmission is inhibited on communication port 1 of my GSE 350 Touch Panel?
If data transmission is inhibited due to a deasserted handshake on communication port 1 of your GSE Touch Panel, press or to abort transmission.
What to do if data transmission is inhibited on communication port 2 of my GSE Touch Panel?
If data transmission is inhibited due to a deasserted handshake on communication port 2 of your GSE Touch Panel, press or to abort transmission.
What does it mean if my GSE 350 Touch Panel displays 'A checksum error occurred during power-up'?
If your GSE Touch Panel displays 'A checksum error occurred during power-up', all annunciators are lit. This means that the EPROM integrity test failed or the EPROM is improperly seated.
What to do if GSE Accessories display shows 'Code03 Over Load'?
If the GSE Accessories display shows 'Code03 Over Load', perform the same checks as for an 'under load' situation.
What does 'EEPROM data could not be read' mean on my GSE Touch Panel?
If your GSE Touch Panel displays 'EEPROM data could not be read', the device is attempting a power-up reset.
What should I do if my GSE 350 displays 'Problem with A/D chip detected'?
If your GSE Touch Panel displays 'Problem with A/D chip detected', disconnect any options installed and re-power the unit.
What does 'Unit ~ Seald' mean on GSE Accessories, and how to fix it?
The message 'Unit ~ Seald' on GSE Accessories means access to the Setup or Calibration Mode was denied. You should check the internal “YES/NO” program jumper.
What does 'Par-Er' mean on GSE Accessories?
The message 'Par-Er' on GSE Accessories indicates that the selected parity (P202) does not match that of the connected device.
What does 'Buf-Er' mean on GSE Accessories?
The message 'Buf-Er' on GSE Accessories means that the receive buffers capacity was exceeded, indicating a handshaking problem. Check P204 and verify proper communication port connections.
Instructions for sampling and counting parts, including viewing average piece weight.
Guides on entering target values and tolerances for percentage checkweighing.
Instructions for entering target values for the fill program, including pre-act values.
Steps to enter target and pre-act values for batching ingredients in Model 350 and 355.
Instructions for entering target and pre-act values for the discharge program.
How to enter target values for combined fill and discharge operations.
Guides on entering absolute target values and tolerances for checkweighing.
How to enter target values and tolerances for target deviation checkweighing.
Lists and explains common operational error codes and messages encountered.
General| Display Type | TFT LCD |
|---|---|
| Touch Panel | Yes |
| Touch Technology | Resistive |
| Power Supply | 24 VDC |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 60°C |
| Interface | Ethernet |
| Humidity | 10% to 90% non-condensing |
| Protection Level | IP65 |
| Operating Voltage | 24V DC ±10% |
