15
ZY120 6-20kVA (11) User Manual EN rev.04.doc
5. INSTALLATION
The system should be installed and wired only by qualified electricians in accordance with
applicable safety regulations.
NOTICE：UPS operation in sustained temperature outside the range of 15-25
C (59
-77
F)
reduces battery life.
5.1 Unpacking and Inspection
1) Unpack the packaging and check the package contents. The shipping package contains:
● 1 UPS
● 1 user manual
● 1 red Anderson connector and 1 black Anderson connector (6K and 10K)
● 2 output cables
● 2 cable entry protector (6K and 10K)
● 1 CD with monitoring software UPSilon , setting software MTR e driver.
2) Inspect the appearance of the UPS to see if there is any damage during transportation. Do not
turn on the unit and notify the carrier and dealer immediately if there is any damage or lacking
of some parts.
5.2 Connect Input/Output Power
1. Notes for installation
1) The UPS must be installed in a location with good ventilation, far away from water,
inflammable gas and corrosive agents.
2) Ensure the air vents on the front and rear of the UPS are not blocked. Allow at least 0.5m
of space on each side.
3) Condensation to water drops may occur if the UPS is unpacked in a very low temperature
environment. In this case it is necessary to wait until the UPS is fully dried inside out
before proceeding installation and use. Otherwise there are hazards of electric shock.
2. Installation
Installation and wiring must be performed in accordance with the local electric code and the
following instructions by professional personnel.
It’s suggested to install input protection breaker upstream the UPS. Here below the references:
ZY120-6K / KS: 32A curve C 250Vac , 40A-2P curve C 250Vac (Ks)
ZY120-10K / KS: 63A-2P curve C 250Vac,
To Next Page
Loading...
