Setting Direction Of Operation
For using the operator the first time, it is necessary to set the direction of operation.
1.
Connect power supply; both “UP” and “DOWN” LEDs are on.
2.
Initialize the operational direction by pressing “UP” or “DOWN” button for the correct
direction setting according to the illustrations below. The corresponding LED is on
upon key input.
View View
3.
Press “RADIO SET” button to confirm setting. The “OK” LED is on with 2 beeps.
x2
Caution: Make sure the drive unit is set for the correct side of installation!
To reset installation direction, press the “LIMIT” button constantly until both “UP”
and “DOWN” LEDs are ON, repeat steps 2 and 3 to set the appropriate direction.
To Next Page
Loading...
Need help?
General
