Guldmann GH3 Series - Power Supply

To Next Page

To Previous Page

• If the rail system can not be rated to the same max load as the hoist,

then extra brackets must be installed according to the Installation

guide (distance between bracket according to max load).

Class I equipment

Fixed rail systems are class I equipment and must be installed by a qualied

technician or by Guldmann Service Team.

Equipment is disconnected from Supply Mains by breaking the mains breaker

switch.

Class II equipment

Mobile equipment is class II epuipment (marked with double-encassed

symbol) and can be connected to the mains direct by the user.

Equipment is disconnected from Supply Mains by detaching the mains plug

from the wall outlet.

Emergency stop device

The emergency stop device must be reset in order to connect power to the

product. To do this, push the yellow reset button (see point 2.09).

1.07 Power supply

GH3 is equipped with batteries that require regular recharging. The power

supply for charging and the battery charging point must be connected by a

qualied engineer or by Guldmann Service Team.

The transformer supplied must always be used.

Safety concerning static electricity (ESD)

Service technicians and installers must use an ESD-safety package

consisting of a mat, a ground wire, and a bracelet. The technician/installer

connects the mat to a grounding point. The technician/installer must then

put on the bracelet and connect it to the mat. If it is not possible to nd a

grounding point, the mat and the bracelet must be used as a minimum.

Only then is it allowed to work with the PCB Board or components where it is

possible to come into contact with the PCB Board.

Related product manuals