Guldmann GH3 Series - Scale Module (GH3 with Integrated Scale Module)

Menu Start
Scale
KG
Show
Statistics
2008.04.22
Next service
Setup
Setup
Change
Scale
KG
19
© Guldmann GB/US-05/2010 • # 550393
© Guldmann GB/US-05/2010 • # 550393
© Guldmann GB/US-05/2010 • # 550393
© Guldmann GB/US-05/2010 • # 550393
Setting the units, kg/lbs (Scale module)
1. Press any key on the hand control to activate the hoist.
When the lifting module is activated, the display on the hand control is
switched on and the Guldmann logo “G” appears.
2. Select “Menu” using the function key located below the display
3. Then select until the “Setup” menu appears in the display.
4. Select “Setup” and then until the “Units” menu appears in the display.
5. Select “Change” to switch between the units kg and lbs, and conrm the
selection by pressing “OK”.
6. Select to return to the start menu.
7. The display in the hand control switches off automatically after use
(approx. 8 min). (See the complete menu summary, section 2.04,
Supplementary modules, GH3)
2.06 Scale module (GH3 with integrated scale module)
The GH3 with scale module (option) provides the facility to determine the
user’s weight.
Warning!
The integrated scale in GH3 is not approved to determine mass in medical
practice, including the weighing of patients in connection with health moni-
toring, diagnosis and medical treatment.
(The provisions for medical weighing are specied in accordance with EEC
Directive 90/384)
Shock effects
The GH3 with scale module includes high-sensitive sensors to register mass
corresponding to the nominal recommended load. The sensors are highly
sensitive and can be damaged by the effects of shock, for example pulling
the GH3 at extreme speed into an end stop.
Operation
Always reset the scale module before weighing takes place. When resetting
the unit, the lifting hanger and the desired lifting sling must be
attached under the hoist.