CONFIGURATION
103
Remote Control Interface
The Remote control interface section describes how to set up the
USB interface for PC connection. Remote control command details
are described in the GDS-1000A-U Programming Manual.
1. Connect the USB cable to
the USB slave port.
2. When the PC asks for the USB driver, select
dso_vpo.inf V1.06 or above for Windows
XP/Vista/7(32/64 bit) which are downloadable
from the GW website, www.gwinstek.com,
GDS-1000A-U product corner.
3. On the PC, activate a terminal application such
as Hyper Terminal. To check the COM port
No., see the Device Manager in the PC. For
WindowsXP, select Control panel ā System ā
Hardware tab.
4. Run this query command via the terminal
application.
*idn?
This command should return the manufacturer,
model number, serial number, and firmware
version in the following format.
GW, GDS-1152A-U, XXXXXXX, V1.00
5. Configuring the command interface is
complete. Refer to the programming manual for
the remote commands and other details.
To Next Page
Loading...
