GDS-800 Series Digital Storage Oscilloscope Operation Manual
44
UTILITY: The utility menu provides abundant sub menus: Printer menu, Interface
menu, (Beep), Language, self-cal menu, System Inform, Go-No Go
menu, and No Go When.
z Printer Menu: If a printer is connected and properly configured,
GDS-820/GDS-840 series can print a hard copy of the LCD display. Press F1
softkey again to select printer. This oscilloscope supports the following printers:
z Type HP: Both Hewlett-Packard’s LaserJet laser printers and DeskJet
inkjet printers supported.
Press the pushbutton of HARDCOPY pushbutton to start printing from any time
after printer is properly configured.
Note: GDS-800 series oscilloscopes do not support any GDI printers.
Note: The USB of this oscilloscope is “DEVICE” only, this oscilloscope
DO NOT support any USB printers.
Note: Printer menu is available for GDS-806S/C and GDS-810S/C with
interface option, GDS-820S/C and GDS-840S/C.
z Interface Menu: This oscilloscope can transfer data between the scope and
other instrument over the RS-232, USB, or GPIB interface. Press F1 softkey to
select the GPIB location.
Note: Interface menu is only available for GDS-806S/C and GDS-810S/C
with interface option, GDS-820S/C and GDS-840S/C.
For RS232 setup
z Type RS232: Select RS-232 communication port.
z Baud rate: Transmission rate in characters per second. Transmission rate
selections are: 2400, 4800, 9600, 19200, and 38400 baud.
z Stop bit: Press the adjacent pushbutton to select “1” or “2” bits.
To Next Page
Loading...
