GDS-800 Series Digital Storage Oscilloscope Operation Manual
54
2. Save all settings of channel one to memory location one (M 01). (a). Press
SAVE/RECALL button and F3 softkey to select memory location; select memory
location one (M 01) by rotating the VARIABLE knob. (b). Press F4 softkey to
save the channel one settings.
Figure 5-27: Save channel one settings to memory location one (M 01)
3. The input for channel two is a 6Vpp, 1MHz square wave; (a). Press CURSOR
button and F1 softkey to select channel tow as source; (b). Press F2 and F3
softkey to enable horizontal and vertical cursors; (c). Adjusting the two cursors to
proper position by rotating the VARIABLE knob.
Figure 5-28: Adjusting the horizontal and vertical position for channel two input
To Next Page
Loading...
