GW Instek GPT-9800 - Page 107

REMOTE CONTROL
107
Display
When the panel is being remotely controlled via
the USB, RS232 or GPIB interfaces, RMT will be
displayed on the screen.
I R G B A CW D CW
F R E Q = 0 H z 6
0 100
k V
RA C = F FO
TMR
MT I E = 0 0 3 . 2 SR
0 0 m AER F =# 0 .0
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
2M A UN 0 0_2M A N U = * * * - 0 0
m A
Return to Panel Control
Background
When the instrument is remotely controlled all
panel keys except the STOP button are
disabled.
Steps
1. When RMT is on the display, press
the STOP button. The panel goes to
the READY status.
STOP
2. From the READY status the tester
can go into one of two states: TEST
or VIEW.
 To put the tester into VIEW status,
press the MANU/AUTO key.
 To put the tester in TEST status,
press the START button. This will
start the manual test/automatic
test. For more details on running a
manual test or automatic test, see
pages 58 and 88, respectively.
MANU/AUTO
START
Note
To put the tester back to RMT, simply issue another
remote control command.