10
(1) Front square-holed post (2) Load-bearin
screw
(3) Rear panel (4) Rear square-holed post
(5) Rear mountin
bracket (6) Screw used to attach rear mountin
brackets to rear posts
(7) Front mountin
bracket
After the switch is pushed into the rack, make sure the upper edge of rear mounting brackets makes
close contact with the load-bearing screw, as shown in Figure 9.
Figure 9 Front and rea
r mounting bracket installation (1)
(1) Rear panel (2) Rear square-holed post
(3) Load-bearin
screw (4) Rear mountin
bracket
7. Have another person to attach the other end of the front mounting brackets to the front brackets
with M6 screws and cage nuts and make sure front and rear mounting brackets have attached the
switch in the rack securely, as shown in Figure 10.
To Next Page
Loading...
