H3C S5120-EI Series - S5120-28 C-Pwr-Ei

37
(5) Port mode LED (Mode) (6)
System status LED (PWR)
(7) RPS status LED (RPS) (8) Port status LED mode switching button
(9) SFP port (10) SFP port status LED
Figure 44 S5120-48P-EI rear panel
(1)
A
C power input (2) RPS power input (with filler panel)
(3) Groundin
g
screw (4) "DO NOT REMOVE" label
NOTE:
The S5120-48P-EI does not support interface cards.
S5120-28C-PWR-EI
The S5120-28C-PWR-EI includes two models: PoE and PoE+.
• The front panels of the PoE and PoE+ models are the same in appearance. See Figure 45.
• T
he PoE+ model has a PoE+ label on its rear panel, as shown in Figure 46. T
he maximum PoE
power per port is 30 W.
• The PoE model has no PoE+ label on its rear panel, as shown in Figure 47. T
he maximum PoE power
per port is 15.4 W.
For more information about the PoE power supply, see Table 8.
Figure 45 S5
120-28C-PWR-EI front panel
(1) 10/100/1000 Base-T auto-sensin
g
Ethernet port
(2) 10/100/1000 Base-T auto-sensing Ethernet port status LED
(3) 1000 Base-X SFP port (4) 1000Base-X SFP port status LED
(5) Console port (6) Seven-se
g
ment LED
(7) Port mode LED (Mode) (8) System status LED (PWR)
(9) RPS status LED (RPS) (10) Interface card 1 status LED (MOD1)
(11) Interface card 2 status LED (MOD2) (12) Port status LED mode switchin
g
button