H3C S5120-EI Series - Mounting the Switch on a Workbench

11
Figure 10 Front and rear mounting bracket installation (2)
(1) Load-bearin
g
screw (2) Rear mountin
g
bracket
(3) Front panel (4) Screw used to attach front mounting brackets to front brackets
(5) Front mountin
g
bracket (6) Front square-holed post
Mounting the switch on a workbench
In many cases, standard 19-inch racks are not available. Switches are often placed on clean
workbenches.
To place the switch on a workbench:
1. Make sure the workbench is flat and sturdy.
2. Place the switch with bottom up carefully, and then clean the round holes on the chassis bottom
with dry cloth.
(1)
(2)
(3)
(4)
(5)
(6)