H3C S5120-SI Series

4-9
Flash fast selftest..........................OK!
CPLD selftest................................OK!
Switch chip selftest.........................OK!
PHY selftest.................................OK!
Please check leds......................FINISHED!
User interface aux0 is available.
Press ENTER to get started.
The appearance of "Press ENTER to get started" indicates that the automatic startup of the switch is
complete.
Press Enter. The following prompt is displayed:
<H3C>
You can configure the switch now.
The H3C series switches provide abundant command views. For detailed descriptions about the
configuration commands and CLI, refer to H3C S5120-SI Series Ethernet Switches Operation Manual
and H3C S5120-SI Series Ethernet Switches Command Manual.