41
Figure 74 Drive information
Locating drives
1. Select the target drive on the screen as shown in Figure 74 and press Enter.
2. On the screen as shown in Figure 75, perform one of the following operations:
Select Device Information and press Enter to view drive information.
Select Identify Drive and press Enter to locate the drive. The Fault/UID LED on the drive
turns steady green.
Figure 75 Locating the drive
Clearing storage controller settings
1. On the storage controller configuration screen as shown in Figure 76, select Configure
Controller Settings and press Enter.
To Next Page
Loading...
Need help?
General
