35 
[AC-acl-ipv4-adv-3002] rule permit ip destination 192.168.0.3 0 
[AC-acl-ipv4-adv-3002] quit 
# Create a traffic class named classifier_dbserver, and use ACL 3000 as the match criterion in the 
traffic class. 
[AC] traffic classifier classifier_dbserver 
[AC-classifier-classifier_dbserver] if-match acl 3000 
[AC-classifier-classifier_dbserver] quit 
# Create a traffic class named classifier_mserver, and use ACL 3001 as the match criterion in the 
traffic class. 
[AC] traffic classifier classifier_mserver 
[AC-classifier-classifier_mserver] if-match acl 3001 
[AC-classifier-classifier_mserver] quit 
# Create a traffic class named classifier_fserver, and use ACL 3002 as the match criterion in the 
traffic class. 
[AC] traffic classifier classifier_fserver 
[AC-classifier-classifier_fserver] if-match acl 3002 
[AC-classifier-classifier_fserver] quit 
# Create a traffic behavior named behavior_dbserver, and configure the action of setting the local 
precedence value to 4. 
[AC] traffic behavior behavior_dbserver 
[AC-behavior-behavior_dbserver] remark local-precedence 4 
[AC-behavior-behavior_dbserver] quit 
# Create a traffic behavior named behavior_mserver, and configure the action of setting the local 
precedence value to 3. 
[AC] traffic behavior behavior_mserver 
[AC-behavior-behavior_mserver] remark local-precedence 3 
[AC-behavior-behavior_mserver] quit 
# Create a traffic behavior named behavior_fserver, and configure the action of setting the local 
precedence value to 2. 
[AC] traffic behavior behavior_fserver 
[AC-behavior-behavior_fserver] remark local-precedence 2 
[AC-behavior-behavior_fserver] quit 
# Create a QoS policy named policy_server, and associate traffic classes with traffic behaviors in 
the QoS policy. 
[AC] qos policy policy_server 
[AC-qospolicy-policy_server] classifier classifier_dbserver behavior behavior_dbserver 
[AC-qospolicy-policy_server] classifier classifier_mserver behavior behavior_mserver 
[AC-qospolicy-policy_server] classifier classifier_fserver behavior behavior_fserver 
[AC-qospolicy-policy_server] quit 
# Apply the QoS policy named policy_server to the incoming traffic of GigabitEthernet 1/0/1. 
[AC] interface gigabitethernet 1/0/1 
[AC-GigabitEthernet1/0/1] qos apply policy policy_server inbound 
[AC-GigabitEthernet1/0/1] quit