4
DEUTSCHENGLISH FRANÇAIS ITALIANO ESPAÑOL NEDERLANDS
PORTUGUÊS
SVENSKA
© HAAG‑STREIT AG, 3098 Koeniz, Switzerland ‑ HS‑Doc. No. 1500.7221019.04030 / 2024 – 04
1 Safety
DANGER!
Failure to comply with these instructions may result in material damage
or pose a danger to patients or users.
WARNING!
These warnings must absolutely be complied with to guarantee safe op-
eration of the product and to avoid any danger to users and to patients.
NOTE!
Important information, please read carefully.
1.1 Comments on these instructions for use
NOTE!
In these instructions for use the point is used as decimal separator.
1.2 Ambient conditions
Transport Temperature −40 °C ... +70 °C
Air pressure 500 hPa ... 1060 hPa
Relative humidity 10 % ... 95 %
Storage Temperature −10 °C ... +55 °C
Air pressure 700 hPa ... 1060 hPa
Relative humidity 10 % ... 95 %
Use Temperature +10 °C ... +35 °C
Air pressure 800 hPa ... 1060 hPa
Relative humidity 30 % ... 90 %
1.3 Shipment and unpacking
• Before unpacking the device, check whether the packaging shows traces of im-
proper handling or damage. If this is the case, notify the transport company that
delivered the goods to you.
• Unpack the device together with a representative of the transport company.
Make a report of any damaged parts. This report must be signed by you and by
the representative of the transport company.
• Leave the device in the packaging for a few hours before unpacking it (condens-
ation).
• Check the device for damage after it is unpacked.
• Return defective devices in the appropriate packaging.
• Store packaging material carefully so that it can be used for potential returns or
when moving.
1.4 Installation warnings
WARNING!
• Do not modify this device without authorization of the manufacturer.
Installation and repairs may only be performed by trained special-
ists.
• Any third-party device must be connected in compliance with the EN
60601-1 standard.
• Only original Haag-Streit spare parts may be used.
• Use of this device adjacent to or stacked with other equipment
should be avoided because it could result in improper operation. If
such use is necessary, this device and the other equipment should
be observed to verify that they are operating normally.
• The device should be set up in such a way that the plug is always
easily accessible and the device can easily be disconnected from
the mains.
To Next Page