Serial Interface
tandard
Extended
1
NAMUR
1
Command
Fault
F126
=
"RAMP ERROR"
f you select a segment for which not all the parameters have been defined, error
message "F126" appears. In this case either select another segment or define the
Darameters.
KRS
I
-
1
Start ramp
If the circulator has reached the start temperature, you can start the ramp with
VV
-
RS.
The command
W
RP "interrupt ramp" is only available while a program is run-
ling, i.e. if the commands
W
AS <no.> "run to start temperature" or
W
RS "start
.ampen have been entered bef6e.lf this is not the case
"F127"
appears when
~ntering the command
W
-
RP "interrupt ramp".
!
If a ramp segment runs out, the next segment does not start automa-
tically.
Stop ramp
Interrupt ramp
N
RB
N-RP
-
To start the next ramp segment, once again enter the following commands:
fou can interrupt the program with W-RP. Then the segment time is hold and the
nomentanous temperature is maintained. The interrupted program can either be
:ontinued with W RS or another segment can be selected with
W
-
SNxx.
Fault
F127
=
"PAUSE ERROR"
-
-
Run to start temperature
(segment no.: 1-6)
Start ramp
Fault
F001
=
"COMMAND UNKNOWN
"
If a command is entered that is not defined in any set of commands, error mes-
sage F001 appears. In this case enter one of the commands listed above.
The single ramps can be repeated cyclically:
Call up for information:
R-R I
-
remaining ramp time and
sensor value.
R RZ
I
-
-
W
-
RZ
-
<PgNo.>
-
<number>
-
R
-
XR
1
-
(Read status ramp continuation
Answer
,,
XR-< program no.
>-<
segment no.
>-<
segment remain time
>-
<
setpoint step
>-<
actual ramp setpoint
>-<
segment end temperature
>
,,
I
Call up number of cycles
Set number of cycles
-
"
-
"
=
blank
64
Read remaining ramp time and
external sensor value.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...