General Instrument Operation
General Instrument Operation
Page 24
5940018Operation.fm
2.3.4 Communications with a Printer or Computer
2.3.4.1 Selecting the Destination for Sent Data
2.3.4.2 Changing the Destination of Sent Data
1. Follow steps 2 through 4 in section 2.3.4.1, above.
2. Touch
OK. Use the printer or computer icon whenever the data destination
needs to be changed.
1. Connect the appropriate cable from the instrument to the
printer or computer as described in Section 1.3 Cable Connections.
2. From the Main Menu, touch
Instrument Setup. From a Hach
Program window or other reading mode, touch
Options, then
Instrument Setup.
3. Touch the
Computer & Printer menu item.
4. Touch
Computer or Printer.
5. Touch
OK to accept the destination for the sent data.
6. Touch
Setup to bring up a menu of communication settings.
Please note:
• Data can be sent to only one destination at a time. The
instrument saves the last computer and last printer setup,
making it easy to switch between the two as necessary.
Note: In the Computer Setup Menu, Default Setup matches the defaults to
those of HachLink™.
• Graphics offers a choice between Hewlett-Packard
Inkjet/Deskjet protocol and Epson Dot Matrix protocol, or
no graphics (text only). Do not select the text only option for
printing graphs.
7. After the settings are configured, touch Close.
8. Use the Printer or Computer icon to send data to the chosen
device.
To Next Page
Loading...
