Hach DR/2400 - Section 4 Working with Data; 4.1 The Datalog

Working with Data
5940018Data.fm Page 37
Section 4 Working with Data
4.1 The Datalog
This section describes how to work with data from the following reading modes:
Hach Programs, Single-wavelength, and User Programs.
4.1.1 Storing Data to the Datalog
The DR/2400 datalog will store up to 1000 data points. A complete record of the
analysis is stored, including the date, time, results, sample ID, and operator ID.
4.1.2 Recalling, Sending, and Erasing Data from the Datalog
To recall data from the Datalog:
Touch
On to turn on the filters. Touch the checkbox next to each filter to be
applied. Change the criteria for each type of filter by selecting it and entering the
desired settings. Touch
OK. Only the data that match the criteria will appear.
To see all the data again, return to this screen and turn filters
Off.
To store data, touch the
Store Data icon on any reading screen, or
from within any Options Menu.
1. Touch the Recall Data icon.
2. If necessary, touch
Datalog.
3. Touching any data point on the Datalog screen causes it to be
highlighted.
Note: Alternatively, touch Options from one of the modes listed in Section 4.1, and
then Recall Data.
Details
Touch
View Details on the Recall Data screen to view all the
information about the highlighted data point.
Filters
To select data by
• sample ID,
• operator ID,
• parameter,
• date,
or any combination of the four, touch
Filters on the Recall Data screen.