What to do if Hach LPV445.99.09110 show error E-07?
If your Hach Measuring Instruments display error E-07, it is due to a configuration or setting error. Enter the correct standard concentration. You can also reset the mainboard to factory settings.
What to do if Hach LPV445.99.09110 Measuring Instruments show error E-14?
If your Hach Measuring Instruments display error E-14, it means the signal of zero measurement is too low. Use a sample cell filled with water and try again. Also, check the service log for other error messages. If the issue persists, consider replacing the LED, optical filter, or detector.
What does error E-09 mean on Hach LPV445.99.09110 Measuring Instruments?
Error E-09 on Hach Measuring Instruments indicates a data flash error on the mainboard. Push and hold for 5 seconds to reset the instrument. You can also reset the instrument to its hardware reset state.
What to do if Hach Measuring Instruments show error E-32?
If your Hach Measuring Instruments display error E-32, it means the application update failed during transmission. Update the instrument again and check the service log for other error messages.
General| Model | LPV445.99.09110 |
|---|---|
| Category | Measuring Instruments |
| Manufacturer | Hach |
| Resolution | 0.01 NTU |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Temperature Range | 0 to 50°C (32 to 122°F) |
| Type | Turbidity Meter |
| Measurement Range | 0 - 1000 NTU |
| Light Source | LED |
| Material | Stainless Steel |
To Next Page