g. Select Controller > Connectivity > HCNB > HCNB. Select On. Push OK to restart the
controller.
Note: Wait until the controller restarts. Do not touch the display or go to other menus or an error message
will show.
2. Set the Controller 2 configuration as follows:
a. To connect to Claros (optional), push the main menu icon, then select Controller >
Connectivity > Claros. Set to on.
b. Push the main menu icon, then select Controller > Connectivity > LAN > Ethernet ports.
Select Chaining.
c. Go to Controller > Connectivity > HCNB > HCNB. Make sure that HCNB is set to Off.
d. Select Controller > Connectivity > HCNB > Interface. Select ALL.
e. Select Controller > Connectivity > HCNB > Auto detection. Select On.
f. Select Controller > Connectivity > HCNB > HCNB. Select On. Push OK to restart the
controller.
Note: Wait until the controller restarts. Do not touch the display or go to other menus or an error message
will show.
3. Set the Controller 3 configuration as follows:
Note: Make sure to connect the Ethernet LAN cable to LAN port 1 and industrial Ethernet cable to IEP port 1.
a. Push the main menu icon, then select Controller > Connectivity > LAN > Ethernet ports.
Select Split or Mix IEP.
b. Go to Controller > Connectivity > HCNB > HCNB. Make sure that HCNB is set to Off.
c. Select Controller > Connectivity > HCNB > Interface. Select ALL.
d. Select Controller > Connectivity > HCNB > Auto detection. Select On.
e. Select Controller > Connectivity > HCNB > HCNB. Select On. Push OK to restart the
controller.
Note: Wait until the controller restarts. Do not touch the display or go to other menus or an error message
will show.
English
13
To Next Page
Loading...
