Figure 1 Controller Ethernet ports options
1 No Ethernet ports (LAN configuration: none) 5 LAN Ethernet connector (LAN configuration:
mix IEP)
2 Digital SC connectors 6 Industrial Ethernet protocol connector (LAN
configuration: mix IEP)
3 Controller 7 Industrial Ethernet protocol connectors (LAN
configuration: IEP only)
4 LAN Ethernet connectors (LAN configuration:
split or chaining)
Note: LAN = LAN Ethernet connector. IEP = Industrial Ethernet protocol connector.
2.1 LAN connection
The controller is supplied with two Ethernet connectors based on the controller configuration.
Regardless of the supplied controller, the user must configure the Ethernet ports to the applicable
option.
Note: An Ethernet port upgrade may be necessary based on the controller configuration. Refer to the
documentation supplied with the upgrade kit.
1. Use a user-supplied Ethernet cable (M12 to RJ45) to connect the controller to a device with
internet connection. Refer to Installation on page 4.
2. Push the main menu icon, then select Controller > Connectivity > LAN > Ethernet ports.
3. Enter the settings.
Option Description
None The controller does not have Ethernet ports or the Ethernet ports are not configured.
The controller is supplied with the option None by default.
Note: When the controller configuration is set back to the factory settings, all of the LAN
connection settings are lost and the Ethernet ports are set back to None.
Chaining The two Ethernet ports are configured for LAN connectivity. When selected, the LAN
port configuration setting shows on the LAN menu. The two Ethernet ports have the
same port configuration. Select this option to share the internet connection with
other controllers (daisy chain topology) or to connect the controller to Claros and
HCNB through the Ethernet cable.
English 5
To Next Page
Loading...
Need help?
General
