50
Troubleshooting
Example of event log download using DataCom
7.4 Data log
Measured data is automatically logged based on the setting of the
data log interval. If, however, there is a calibration or verification
being performed, the data log will be interrupted since the values of
the measurements do not represent the normal process. The data
log interval in the following example is set at 15 minutes.
Example of data log download using DataCom
Baseline 13 Serial Number Expected Operator
AC update start 14 — — —
AC update done 15 — — —
AC update fail 16 — — —
AC internal fail 17 — — —
AC external fail 18 — — —
Flash erase 19 — — —
DD update 20 — — —
Service mode 21 0 = Off, 1 = On — —
15:00 01/09/06 BUBBLE REJECT 0 1
1/9/2006 15:00 BUBBLE REJECT 0 0
1/9/2006 15:00 SIGNAL AVG 1 2
1/9/2006 15:00 SIGNAL AVG 1 1
1/9/2006 15:00 DATALOG INTRVL 2 9
1/9/2006 15:01 OUT MODE EVENT 12 1
1/9/2006 15:01 CALIBRATION 4 2100 1.51 G7
1/9/2006 15:01 BASELINE EVENT 13 7 2090.4 G7
1/9/2006 15:02 OUT MODE EVENT 12 2
1/9/2006 15:02 VERIFICATION 5 7 2090.4 2091.1 GS7
Table 9 Event log list (continued)
Event Event # Data1 Data2 Data3
Serial Number: FFFFFFFFFFFF
Device ID: 26
Manufacture ID: 0
Time Channel 1
1/18/2006 12:15 2009.04
1/18/2006 12:30 2009.71
1/18/2006 12:45 2010.316
1/18/2006 13:00 2009.096
To Next Page
Loading...
Need help?
General
