Fig.4-13
Water Supply Connection
It is recommended to have this product installed by
Note: For further installation details refer to the instructions
Pressure of the cold water supplied to the automatic
icemaker is between 0.15-0.6 Mpa.
The water tube should be of an appropriate length,
usually 8 metres, and should be free of bends after
being inserted into place. If the water pipe is too long
ice and cold water content.
•
The water filter is there to filter impurities in the water,
and to make ice clean and hygienic. It cannot sterilise
or destroy anything , so be certain to connect the water
pipe to a drinkable water source.
Fitting the Water Filter
Measure out and cut the length of pipe required from the
supply. Make sure that you achieve a square cut using a sharp
knife.
(Fig.4-13).
groove as shown (Fig.4-14).
Connect the end into the plastic adaptor (Fig.4-15)
.
Screw
the adaptor onto a suitable ½” BSP connector water outlet.
Open the wa
water pipe joints and allow the water to run until it is clear.
Comissioning the Water Dispenser
for 1 minute. Do not press for more than 1 minute to prevent
overheating of the pad activator solenoid. Cold water will
a qualified technician.
Automatic water system,do not manually add water.
If the ice maker is turned on but the appliance is not
connected to water,the ice maker will not work.
Fig.4-15
!
Fig.4-16
Access the water valve assembly at the back of the
refrigerator.
Push the pipe into the valve assembly
(Fig.4-16).
DO NOT connect to the water supply when the
ambient temperature is below 0°C, otherwise the
water pipe may freeze.
Always connect to the drinking water supply.
Keep the water pipe away from heat sources.
GB
To Next Page
Loading...
