Why is my Haier HW110-B14979S8EU1 not filling with water?
If your Haier Washer isn't filling with water, here's what to check: * Ensure the water tap is open. * Inspect the inlet hose for kinks. * Unblock the inlet hose filter. * Verify the water pressure is at least 0.03 MPa. * Ensure the door is properly closed. * Confirm there is a water supply.
How to fix drainage failure in Haier HW110-B14979S8EU1 Washer?
If your Haier Washer is experiencing drainage failure, consider the following: * Unblock the drain hose. * Clean the pump filter. * Ensure the drain hose is properly installed and not higher than 100 cm above floor level.
Why is my Haier Washer not cleaning clothes properly?
If your Haier Washer isn't cleaning clothes well enough, consider these: * Select a different program that better suits the degree of soiling. * Use the correct amount of detergent, appropriate for the pollution level and according to the manufacturer's specifications. * Reduce the load size. * Make sure that the laundry is not packed too tightly in the drum.
What to do if Haier HW110-B14979S8EU1 Washer shows drainage error?
If your Haier Washer displays a drainage error because water isn't fully drained within 6 minutes, you should: * Clean the pump filter. * Check the drain hose installation.
Why is the spinning cycle not working on my Haier HW110-B14979S8EU1 Washer?
If spinning fails in your Haier Washer, it is likely due to an unbalance of laundry. Check the machine load and laundry, and then run the spinning program again.
How to fix lock error on Haier Washer?
If you're getting a lock error on your Haier Washer, make sure that the door is shut properly.
How to stop Haier HW110-B14979S8EU1 Washer from vibrating so much?
If your Haier Washer vibrates strongly during spinning, check these: * Remove all transportation bolts. * Ensure the appliance is on solid, level ground. * Check the load weight and balance inside the machine.
Why is my Haier HW110-B14979S8EU1 Washer draining while filling?
If your Haier Washer drains while filling, it could be due to: * The drain hose being installed incorrectly. * The drain hose end being submerged in water. Make sure the drain hose is properly installed and is not in water.
Why does my Haier Washer keep pausing?
If your Haier Washer pauses during operation, consider the following: * Check for any error codes on the display. * The issue may be due to the load pattern. * The programme may be performing a soaking cycle. To resolve this, you can reduce or adjust the load, or cancel the program and restart it.
What to do if Haier Washer water level not reached?
If the water level isn't reached after 12 minutes in your Haier Washer, it may be because: * The tap isn't fully opened, or the water pressure is not normal. * The drain hose is self-syphoning. Make sure that the tap is fully opened and water pressure is normal and check the drain hose installation.
General| Model | HW110-B14979S8EU1 |
|---|---|
| Type | Front Load Washer |
| Capacity | 10 kg |
| Spin Speed | 1400 RPM |
| Energy Efficiency Class | A |
| Color | White |
| Programs | 16 |
| Delay Start | Yes |
| Child Lock | Yes |
| Inverter Motor | Yes |
| Dimensions (H x W x D) | 850 x 590 x 600 mm |
To Next Page