How to fix drainage failure in Haier HW120-BP14959S6 Washer?
To address a drainage failure in your Haier Washer, try these steps: First, unblock the drain hose. Second, clean the pump filter. Finally, ensure the drain hose is properly installed.
Why does spinning fail on my Haier HW120-BP14959S6 Washer?
Spinning may fail on your Haier Washer due to an unbalance of laundry. Check the machine load and laundry, and then run a spinning programme again.
Why does my Haier HW120-BP14959S6 operation stop for a period of time?
If your Haier Washer's operation stops for a period of time, consider display codes, reduce or adjust the load, or cancel the programme and restart it.
How to fix a lock error on Haier HW120-BP14959S6 Washer?
To fix a lock error on your Haier Washer, ensure that you shut the door properly.
What to do if my Haier HW120-BP14959S6 Washer fails to operate?
If your Haier Washer isn't operating, try the following: first, check the programme and start it. Ensure the door is properly closed. Make sure the machine is switched on and check the power supply. Finally, deactivate the child lock.
Why my Haier HW120-BP14959S6 Washer constantly fills with water?
If your Haier Washer is constantly filling with water, check the following: the water tap, the inlet hose, and the inlet hose filter (unblock it if necessary). Also, verify the water pressure, ensure the door is properly closed, and confirm the water supply is on.
How to reduce vibration of Haier Washer while running?
To reduce vibration in your Haier Washer while it's running: remove all transportation bolts, ensure the machine is on solid, level ground, and check the load weight and balance.
How to fix unbalanced load error on Haier HW120-BP14959S6?
To fix an unbalanced load error on your Haier Washer, check and balance the laundry load in the drum and reduce the load size.
What to do if my Haier HW120-BP14959S6 drains while filling?
If your Haier Washer is draining while it's being filled, make sure that the drain hose is properly installed and is not in water.
How to resolve drainage error on Haier HW120-BP14959S6 Washer?
To resolve a drainage error on your Haier Washer, clean the pump filter and check the drain hose installation.
General| Capacity | 12 kg |
|---|---|
| Energy Rating | A+++ |
| Spin Speed | 1400 RPM |
| Noise level (spinning) | 72 dB |
| Color | White |
| Wash Programs | 16 |
| Motor Type | Inverter |
| Noise Level (Wash/Spin) | 54/72 dB |
| Type | Front Load Washer |
Essential checks before operating the washing machine for the first time.
Key safety guidelines for everyday operation and use of the appliance.
A comprehensive table detailing available wash programs, load capacities, and settings.
Steps for adding detergent, switching on, selecting options, and starting cycles.
How to start, interrupt, cancel cycles, and procedures after washing.
Solutions for problems indicated by error codes on the display.
Guidance for resolving issues when no error code is shown.
Critical step to remove bolts used during transport before operation.
How to properly connect the drain hose to various outlets.
Steps for connecting the water inlet and power supply.
To Next Page