150
B. Gas-liquid segregator Replacement - double compressors unit
Step 1. Remove the front panel and release the refrigerant from the system through the stop valve.
Step 2. Remove the anchor bolts of the gas-liquid segregator.
Step 3. Weld to cut the tubes that connecting with the gas-liquid segregator e.g. inlet/outlet pipe of segregator & oil
separator and outlet pipe of bottom oil return solenoid valve. Dismantle the solenoid valve mounting plate.
inlet/outlet pipe of oil separator
outlet pipe of
bottom oil return solenoid valve
inlet/outlet pipe of separator
solenoid valve mount plate
Step 4. After the segregator is removed; put the new one in the position of the original one, and then reverse the
operation in the order of removal. After the segregator is replaced; vacuum the system, recharge the refrigerant and
test run.
To Next Page
Loading...
