EasyManuals Logo
Home>Haier>Air Conditioner>QPCA08

Haier QPCA08 User Manual

Haier QPCA08
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
49-5000543 Rev. 1 9
ENGLISH
INSTALLATION INSTRUCTIONS
LOCATION REQUIREMENTS
Place the air conditioner on a flat, level surface in a
location that is at least 20” (50 cm) from any wall.
NOTE: A minimum clearance of 20” (50 cm) from the air
conditioner to the wall must be maintained to ensure
proper airflow.
Maintain a minimum 20” (50 cm) clearance around the air
conditioner to not block airflow.
Keep the air conditioner free of any obstructions such as
drapes, curtains, blinds, etc.
The exhaust hose should be free of any obstructions.
Do not place the air conditioner on an unstable or raised
surface because it could fall and cause damage or injury.
Do not place the air conditioner in direct sunlight or near
a heat source such as baseboard heaters, stoves, etc.
The window panel can be installed in a window with a
minimum 20” (50.8 cm) to a maximum 48” (121.9 cm)
opening.
Questions? Call GE Appliances at 866.907.1655 or visit our Website at: GEAppliances.com.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT Save these instructions for local
inspector’s use.
IMPORTANT Observe all governing codes and
ordinances.
Note to Installer – Be sure to leave these instructions
with the Consumer.
Note to Consumer – Keep these instructions for future
reference.
Skill level – Installation of this appliance requires basic
mechanical skills.
Completion time – Approximately 1 hour
We recommend two people to install this product.
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
You MUST use all supplied parts and use proper
installation procedures as described in these
instructions when installing this air conditioner.
CAUTION
Do not, under any circumstances, cut or remove the third
(ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminium house wiring may present special problems
consult a qualified electrician.
ÎÕÎÌÝÛÒÌÊÕÛÎÚÞÒÛÎÖÎ×ÝÜ
These models require a 115/120-volt AC,
60-Hz grounded outlet protected with a 15-amp
time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility of
electric shock hazard. If the wall outlet you plan to use is
only a 2-prong outlet, it is your responsibility to have it
replaced with a properly grounded 3-prong wall outlet.
Power cord includes a current
interrupter device. A test and reset
button is provided on the plug case.
The device should be tested on
a periodic basis by first pressing
÷ëèÝÎÜÝåø÷÷òñäñç÷ëèñ÷ëè
ÛÎÜÎÝåø÷÷òñúëìïèóïøêêèçìñ÷ò÷ëè
òø÷ïè÷Òé÷ëèÝÎÜÝåø÷÷òñçòèöñò÷
÷õìóòõìé÷ëèÛÎÜÎÝåø÷÷òñúìïïñò÷
stay engaged, discontinue use of the
air conditioner and contact a qualified
service technician.
RESET
TEST

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Haier QPCA08 and is the answer not in the manual?

Haier QPCA08 Specifications

General IconGeneral
BrandHaier
ModelQPCA08
CategoryAir Conditioner
LanguageEnglish

Related product manuals