- 99 -
- Power Connection
Power is supplied to the Smart7/8/10 series Charting System through a connector on the rear panel of
the display unit.
Route the power cable from the Smart7/8/10 series location to the ship’s power distribution panel.
Connect the black wire to a battery negative (-) terminal of the power panel.
Connect the white wire to a fused battery positive (+) terminal of the power panel ( 12 to 24 Vdc
nominal). If a fused terminal is not available, install an in-line fuse holder.
- Care and Cleaning
Smart7/8/10 series is made to withstand marine elements but a little care ensures a trouble free life.
Accumulations of salt and sand, if not removed, will eventually mar the finish. No solvents or harsh
cleaners should be used. The display unit may be wiped down with a damp cloth while avoiding the
display window. Be careful not to scratch the display window surface. Gently remove any sand or other
grit particles before cleaning the display window. The display window should be cleaned only with
water and a clean soft cloth using very light pressure.
To Next Page
Loading...
