Hama IR360MBT User Manual

5
4.1 LAN connection (wired network)
• Connect aLAN cable of type RJ45 to afreesocket on
your router,switch or access point.
• Connect the other end of the LAN cable to the RJ45 LAN
socket on the radio.
• Make surethat the router is on and that you have an
Internet or network connection.
• If you have questions about router conguration,
please consult the operating manual of the router for
troubleshooting.
• Adetailed description of how to congurethe LAN
connection is given in the Wired network connection
section.
4.2 WLAN/WiFi connection (wireless network)
• Make surethat the router is on and that you have an
Internet or network connection.
• If it is not already activated, activate the WLAN network
of your router.
• If you have questions about router conguration,
please consult the operating manual of the router for
troubleshooting.
• Adetailed description of how to congurethe WLAN
connection is given in the Wireless connection section.
5. Before Getting Started
Note
Adetailed description of the
UNDOK app and the full
scope of functions can be found in our
UNDOK guide at:
www.hama.com-
>
00054837 -
>
Downloads
Notes on use
• Beforeyou can use the streaming radio, you need
to set it up (see Chapter 6) by smartphone using the
UNDOK app.
Getting started with the remote control
Open the battery compartment cover.Itis located on the
rear of the remote control and can be opened by sliding it
in the direction indicated.
TwoAAA batteries areincluded in the delivery,they should
be inserted in the battery compartment of the remote
control. Observe the correct polarity when inserting
batteries. The polarity (+ /-)is indicated in the battery
compartment.
6. Getting started
Note
• Optional, switchable light sources or brightness
sensors result in higher power consumption in the
switched-on state.
6.1 Switching on the radio
• Connect the power cable to aproperly installed socket.
Warning
• Only connect the product to asocket that has been
approved for the device. The electrical socket must
always be easily accessible.
• Disconnect the product from the power supply using
the on/off switch –ifthis is not available, unplug the
power cordfromthe socket.
• Wait until the speaker initialisation procedurehas
nished.
• Press the [play/pause] button
►I I to turn on the speaker.
Note –Turning on for the rst time
• When you turn on the device for the rst time, the
speaker starts in SETUP mode.
• The LEDs (6-8) begin to ash, the LEDs (9) are
constantly lit and the speaker can be connected to
your smartphone using the UNDOK app.

Hama IR360MBT Specifications

General

Brand	Hama
Model	IR360MBT
Category	Radio
Language	English