Hammer N3700 e-classic - Cutting Round Workpieces in the Transverse Direction; Cutting Workpieces on the Upright Edge; Longitudinal Cut of Narrow or Thin Workpieces with the Longitudinal Guide Fence

25
!
Bandsaw
N3700 e-classic / N3800 / N4400
Use an appropriate device with the minimum measure-
ments as depicted in Fig. to avoid the workpiece twisting
during the cutting process.
Fig. 7-9: Cutting a circular workpiece
7.7.2 Cutting round workpieces in the transverse direction
Use an auxiliary fence with the minimum measurements
to guide the workpiece safely.
Fig. 7-10: Auxiliary fence
7.7.3 Cutting workpieces on the upright edge
Use a push stick as depicted in Fig. to prevent your
hands from coming too close to the saw blade.
Fig. 7-11: Push stick
7.7.4 Longitudinal cut of narrow or thin workpieces with the longitudinal guide fence
!Push stick
Operation