76
*#1 $OM%OM$2OMOwner’s Manual
In this mode, you name your Bank, and determine how to recall the Combination Presets.
To locate this mode:
Press the [MENU/EXIT] button and display MENU, then press the [PAGE] button to select
PAGE A and press the [4] PRESET button.
PRESET
BANK NAME
1. BANK NAME (B)
This allows you to name the current Bank using up to 8 letters.
Move the cursor by the [PARAM] button, and choose the letters by the [VALUE] button or the
[VALUE] knob.
The BANK name is recorded at the time of operation, so no recording operation is needed.
PRESET LOAD
This allows you to choose the operation of the Preset Keys.
2. PRESET LOAD - LINK GREAT/PEDAL (B)
This is for setting whether or not to call out the Pedal part Preset simultaneously by the Great
Preset Key.
In this mode, recording a preset on the Great (Lower) manual will also record the Pedal registra-
tion. This was not possible on vintage B-3’s.
3. PRESET LOAD - REGISTRATION SWELL (B)
This is for setting whether or not to call out the registration of the Swell manual by the Swell
Preset Key.
4. PRESET LOAD - REGISTRATION GREAT (B)
This is for setting whether or not to call out the Great Manual registration by the Great Preset Key.
5. PRESET LOAD - DRAWBAR (B)
This is for setting whether or not to call out the Drawbar Parameters by the Swell Preset Key.
PRESET LOAD
Only the Drawbar registrations were recorded
to the Preset Keys on the original B-3. On this
organ, not only the Drawbar registrations, but
also various parameters will be recorded si-
multaneously. These are called “Combination
Presets”.
As the factory default, only the Drawbar reg-
istrations are called out as on the original B-
3(except Bank 4: ShowCase). But you may
save various parameters that can be called
out by turning on the Preset Load.
1
2 3 4 5 6
To Next Page
Loading...
Need help?
General
